Cisco 300 Series Cli Manual page 347

14
347
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
Example 2. The following example sets the relay well known Multicast link-local
destination address per VLAN 200 and enables the DHCPv6 Relay on VLAN 100 if
it was not enabled:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
Example 3. The following example sets the Unicast global relay destination
address and enables the DHCPv6 Relay on VLAN 100 if it was not enabled:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
Example 4. The following example enables DHCPv6 relay on VLAN 100:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
Example 5. The following example disables DHCPv6 relay on VLAN 100:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
interface vlan 100
ipv6 dhcp relay destination FE80::1:2 vlan 200
exit
interface vlan 100
ipv6 dhcp relay destination vlan 200
exit
interface vlan 100
ipv6 dhcp relay destination 3002::1:2
exit
interface vlan 100
ipv6 dhcp relay destination
exit
interface vlan 100
no ipv6 dhcp relay destination
exit
OL-32830-01 Command Line Interface Reference Guide
DHCPv6 Commands