Lldp Timer - Cisco Nexus 7000 Series Reference Manual

lldp timer

lldp timer
To configure the transmission frequency of Link Layer Discovery Protocol (LLDP) updates, use the lldp
timer command. To remove the transmission frequency configuration for LLDP updates, use the no form
of this command.
Syntax Description seconds
Defaults
30 seconds
Command Modes Global configuration mode (config)
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
5.0(1)
Usage Guidelines Make sure that you are in the correct virtual device context (VDC). To switch VDCs, use the switchto
vdc command.
This command does not require a license.
Examples This example shows how to configure the transmission frequency for LLDP updates:
switch(config)# lldp timer 45
switch(config)#
This example shows how to remove the transmission frequency configuration for LLDP updates:
switch(config)# no lldp timer 45
switch(config)#
Cisco Nexus 7000 Series NX-OS System Management Command Reference
234
lldp timer seconds
Transmission frequency in seconds. The range is from 5 to 254.
Modification
This command was introduced.
L Commands
OL-25806-03