Port Security Routed Secure-Address - Cisco 300 Series Cli Manual

Address Table Commands
OL-32830-01 Command Line Interface Reference Guide
Example
The following example sets the port to limited learning mode:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#

5.25 port security routed secure-address

To add a MAC-layer secure address to a routed port. (port that has an IP address
defined on it), use the port security routed secure-address Interface (Ethernet,
Port Channel) Configuration mode command. To delete a MAC address from a
routed port, use the no form of this command.
Syntax
port security routed secure-address
no port security routed secure-address
Parameters
mac-address—Specifies the MAC address.
Default Configuration
No addresses are defined.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode. It cannot be configured for
a range of interfaces (range context).
User Guidelines
This command enables adding secure MAC addresses to a routed port in port
security mode. The command is available when the port is a routed port and in
port security mode. The address is deleted if the port exits the security mode or is
not a routed port.
interface gi14
port security mode max
port security max 20
port security
exit
mac-address
mac-address
5
172