Rate-Limit (Vlan) - Cisco 300 Series Cli Manual

39
767
Example
The following example limits the incoming traffic rate on gi 1 1 to 150,000 kbps.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

39.23 rate-limit (VLAN)

Use the Layer 2 rate-limit (VLAN) Global Configuration mode command to limit the
incoming traffic rate for a VLAN. Use the no form of this command to disable the
rate limit.
Syntax
vlan-id committed-rate committed-burst
rate-limit
no rate-limit vlan
Parameters
•
vlan-id—Specifies the VLAN ID.
•
committed-rate—Specifies the average traffic rate (CIR) in kbits per second
(kbps). (Range: 3-57982058)
•
committed-burst—Specifies the maximum burst size (CBS) in bytes.
(Range: 3000–19173960)
Default Configuration
Rate limiting is disabled.
Committed-burst-bytes is 128K.
Command Mode
Global Configuration mode
User Guidelines
Traffic policing in a policy map takes precedence over VLAN rate limiting. If a
packet is subject to traffic policing in a policy map and is associated with a VLAN
interface gi11
150000
rate-limit
OL-32830-01 Command Line Interface Reference Guide
Quality of Service (QoS) Commands