Cisco 300 Series Cli Manual page 616

Stackable managed switches
Hide thumbs Also See for 300 Series:
Table of Contents

Advertisement

IPv6 Commands
OL-32830-01 Command Line Interface Reference Guide
Syntax
ipv6 nd dad attempts
no ipv6 nd dad attempts
Parameters
value
—The number of neighbor solicitation messages. The acceptable
range is from 0 to 600. Configuring a value of 0 disables duplicate address
detection processing on the specified interface; a value of 1 configures a
single transmission without follow-up transmissions.
Default Configuration
1
Command Mode
Interface Configuration mode
User Guidelines
Duplicate address detection verifies the uniqueness of new Unicast IPv6
addresses before the addresses are assigned to interfaces (the new addresses
remain in a tentative state while duplicate address detection is performed).
Duplicate address detection uses neighbor solicitation messages to verify the
uniqueness of Unicast IPv6 addresses.
The DupAddrDetectTransmits node configuration variable (as specified in RFC
4862, IPv6 Stateless Address Autoconfiguration) is used to automatically
determine the number of consecutive neighbor solicitation messages that are sent
on an interface, while duplicate address detection is performed on a tentative
Unicast IPv6 address.
The interval between duplicate address detection, neighbor solicitation messages
(the duplicate address detection timeout interval) is specified by the neighbor
discovery-related variable RetransTimer (as specified in RFC 4861, Neighbor
Discovery for IPv6), which is used to determine the time between retransmissions
of neighbor solicitation messages to a neighbor when resolving the address or
when probing the reachability of a neighbor. This is the same management
variable used to specify the interval for neighbor solicitation messages during
address resolution and neighbor unreachability detection. Use the
ns-interval
command to configure the interval between neighbor solicitation
messages that are sent during duplicate address detection.
Duplicate address detection is suspended on interfaces that are administratively
down. While an interface is administratively down, the Unicast IPv6 addresses
value
27
ipv6 nd
616

Advertisement

Table of Contents
loading

Table of Contents