Show Interfaces Status - Cisco 300 Series Cli Manual

18
405
Example
The following example displays the configuration of all configured interfaces:
switchxxxxxx# show interfaces configuration
Port Type Duplex
------ --------- ------
gi11 1G-Copper Full
gi12 1G-Copper Full
PO Type Speed
------ ------ -----
Po1

18.19 show interfaces status

To display the status of all interfaces or of a specific interface, use the show
interfaces status Privileged EXEC mode command.
Syntax
show interfaces status
Parameters
•
interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or port-channel.
•
detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Command Mode
Privileged EXEC mode
Default Configuration
Display for all interfaces. If detailed is not used, only present ports are displayed.
Flow
Speed Neg control
----- -------- -------
10000 Disabled Off
1000 Disabled Off
Flow
Neg Control
-------- -------
Disabled Off
[interface-id | detailed
OL-32830-01 Command Line Interface Reference Guide
Ethernet Configuration Commands
Admin Back
State Pressure
----- --------
Up Disabled
Up Disabled
Admin
State
-----
Up
]
Mdix
Mode
----
Off
Off