Show Ip Arp Inspection - Cisco 300 Series Cli Manual

DHCP Snooping Commands
OL-32830-01 Command Line Interface Reference Guide
Example
The following example sets the minimum ARP SYSLOG message logging time
interval to 60 seconds.
switchxxxxxx(config)#

13.28 show ip arp inspection

Use the show ip arp inspection EXEC mode command to display the ARP
inspection configuration for all interfaces or for a specific interface.
Syntax
show ip arp inspection [
Parameters
•
interface-id
—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or Port-channel.
Command Mode
User EXEC mode
Example
The following example displays the ARP inspection configuration.
switchxxxxxx#
show ip arp inspection
IP ARP inspection is Enabled
IP ARP inspection is configured on following VLANs: 1
Verification of packet header is Enabled
IP ARP inspection logging interval is: 222
Interface Trusted
----------- -----------
gi1 1 Yes
gi1
2 Yes
ip arp inspection logging interval
interface-id
]
60
seconds
13
334