Show Macro Auto Processing - Cisco 300 Series Cli Manual

44
847
•
parameter-name value
are the parameters of the built-in or user-defined macro defined in the
macro auto user smartport macro command
Default Configuration
The default value of parameter
For other parameters, the default value is the parameter's default value. For
instance, if the parameter is the native VLAN, the default value is the default native
VLAN.
Command Mode
Global Configuration mode
User Guidelines
By default, each Smartport type is associated with a pair of built-in macros: a
macro that applies the configuration and the anti macro (no macro) to remove the
configuration. The Smartport types are the same as the name of the
corresponding built-in Smartport macros, with the anti macro prefixed with no_.
The value of the parameter $voice_vlan cannot be changed by this command.
Example
To change the parameters of a built-in macro:
switchxxxxxx(config)#

44.12 show macro auto processing

The show macro auto processing EXEC mode command displays information
about which protocols (CDP/LLDP) are enabled and which device types can be
detected automatically.
Syntax
show macro auto processing
Parameters
This command has no arguments or keywords.
—Specifies the parameter name and its value. These
$native_vlan of the built-in Smartport macros is 1.
macro auto built-in parameters switch $native_vlan 2
OL-32830-01 Command Line Interface Reference Guide
Smartport Commands