Auto-Update And Auto-Configuration; Boot Host Auto-Config - Cisco 300 Series Cli Manual

Auto-Update and Auto-Configuration

OL-32830-01 Command Line Interface Reference Guide
6.0
6.1

boot host auto-config

Use the boot host auto-config Global Configuration mode command to enable
auto configuration via DHCP. Use the no form of this command to disable DHCP
auto configuration.
Syntax
boot host auto-config [tftp | scp | auto [
no boot host auto-config
Parameters
•
tftp—Only the TFTP protocol is used by auto-configuration.
•
scp—Only the SCP protocol is used by auto-configuration.
•
auto—(Default) Auto-configuration uses the TFTP or SCP protocol depending
on the configuration file's extension. If this option is selected, the extension
parameter may be specified or, if not, the default extension is used.
•
extension —The SCP file extension. When no value is specified, 'scp' is
used. (Range: 1-16 characters)
Default Configuration
Enabled by default with the auto option.
Command Mode
Global Configuration mode
User Guidelines
The TFTP or SCP protocol is used to download/upload a configuration file.
extension
]]
6
189