Mdix - Cisco 300 Series Cli Manual

18
397
Example
The following example enables Flow Control on port gi 1 1
switchxxxxxx(config)#
switchxxxxxx(config-if)#

18.10 mdix

To enable cable crossover on a given interface, use the mdix Interface (Ethernet)
Configuration mode command. To disable cable crossover, use the no form of this
command.
Syntax
{on | auto}
mdix
no mdix
Parameters
•
on—Enables manual MDIX.
•
auto—Enables automatic MDI/MDIX.
Default Configuration
The default setting is Auto.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example enables automatic crossover on port gi 1 1.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
interface gi11
flowcontrol on
interface gi11
mdix auto
OL-32830-01 Command Line Interface Reference Guide
Ethernet Configuration Commands