Tacacs-Server Host Source-Interface - Cisco 300 Series Cli Manual

TACACS+ Commands
OL-32830-01 Command Line Interface Reference Guide
•
key-string
key
for all TACACS+ communications between the device and the TACACS+
server. This key must match the encryption used on the TACACS+ daemon.
To specify an empty string, enter "". (Length: 0-128 characters). If this
parameter is omitted, the globally-defined key (set in the tacacs-server key
command

tacacs-server host source-interface

•
encrypted-key-string
key
encrypted format.
•
priority
priority
servers are used, where 0 is the highest priority. (Range: 0-65535)
Default Configuration
No TACACS+ host is specified.
The default port-number is 1812.
If timeout is not specified, the global value (set in the tacacs-server timeout
command) is used.
If key-string is not specified, the global value (set in the tacacs-server key
command) is used.
Command Mode
Global Configuration mode
User Guidelines
Multiple tacacs-server host commands can be used to specify multiple hosts.
Example
The following example specifies a TACACS+ host.
switchxxxxxx(config)#
51.2 tacacs-server host source-interface
To specify the source interface which IPv4 address will be used as the Source
IPv4 address for communication with IPv4 TACACS+ servers, use the
tacacs-server host source-interface Global Configuration mode command. To
restore the default configuration, use the no form of this command.
—(Optional) Specifies the authentication and encryption key
—(Optional) Same as key-string, but the key is in
—(Optional) Specifies the order in which the TACACS+
tacacs-server host
command) will be used.
172.16.1.1
51
998