Operation Time - Cisco 300 Series Cli Manual

18
391
switchxxxxxx(config-if)#
Example 3—The following example shuts down vlan 100.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
Example 4—The following example shuts down tunnel 1.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
Example 5—The following example shuts down Port Channel 3.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#

18.4 operation time

To control the time that the port is up, use the operation time Interface (Ethernet,
Port Channel) Configuration mode command. To cancel the time range for the port
operation time, use the no form of this command.
Syntax
time-range-name
operation time
no operation time
interface vlan 100
shutdown
interface tunnel 1
shutdown
interface po3
shutdown
OL-32830-01 Command Line Interface Reference Guide
Ethernet Configuration Commands