Ip System Management Commands; Ping - Cisco 300 Series Cli Manual

IP System Management Commands

OL-32830-01 Command Line Interface Reference Guide
24.0
24.1

ping

Use the ping EXEC mode command to send ICMP echo request packets to
another node on the network.
Syntax
ping [ip] {i pv4-address | hostname
timeout time_out
[ ] [source
ipv6-address | hostname
ping ipv6 {
timeout time_out
[ ] [source
Parameters
•
ip—Use IPv4 to check the network connectivity.
•
ipv6—Use IPv6 to check the network connectivity.
•
ipv4-address—IPv4 address to ping.
•
ipv6-address—Unicast or Multicast IPv6 address to ping. When the IPv6
address is a Link Local address (IPv6Z address), the outgoing interface
name must be specified.
•
hostname—Hostname to ping (Length: 1-160 characters. Maximum label
size for each part of the host name: 58.)
•
packet_size
size
tag. The default is 64 bytes. (IPv4:64–1518, IPv6: 68–1518)
•
packet_count
count
The default is 4 packets. If 0 is entered, it pings until stopped (0–65535).
•
time-out
time —Timeout in milliseconds to wait for each reply, from 50 to
65535 milliseconds. The default is 2000 milliseconds (50–65535).
•
source-address
source
Unicast IPv6 address).
} [ size packet_size
source-address
]
size packet_size
} [
source-address
]
—Number of bytes in the packet not including the VLAN
—Number of packets to send, from 1 to 65535 packets.
—Source address (Unicast IPv4 address or global
24
] [ count packet_count
count packet_count
] [
]
]
474