Cisco 300 Series Cli Manual page 623

27
623
•
vlan 1 is up/up—Indicates the interface status: administrative/operational.
•
IPv6 is enabled, stalled, disabled (stalled and disabled are not shown in
sample output)—Indicates that IPv6 is enabled, stalled, or disabled on the
interface. If IPv6 is enabled, the interface is marked Enabled. If duplicate
address detection processing identified the link-local address of the
interface as being a duplicate address, the processing of IPv6 packets is
disabled on the interface and the interface is marked Stalled. If IPv6 is not
enabled, the interface is marked Disabled.
•
link-local address—Displays the link-local address assigned to the
interface.
•
Global unicast address(es):—Displays the global Unicast addresses
assigned to the interface. The type is manual or autoconfig.
•
Joined group address(es):—Indicates the Multicast groups to which this
interface belongs.
•
MTU is 1500 bytes—Maximum transmission unit of the interface.
•
ICMP error messages—Specifies the minimum interval (in milliseconds)
between error messages sent on this interface.
•
ND DAD—The state of duplicate address detection on the interface
(enabled or disabled).
•
number of DAD attempts:—Number of consecutive neighbor solicitation
messages that are sent on the interface while duplicate address detection
is performed.
•
ND reachable time—Displays the neighbor discovery reachable time (in
milliseconds) assigned to this interface.
•
MLD Version—Version of MLD
Example 2. The show ipv6 interface command displays information about the
specified manual Ipv6 tunnel:
switchxxxxxx# show ipv6 interface tunnel 2
Tunnel 2 is up/up
IPv6 is enabled, link-local address is FE80::0DB8:12AB:FA01
Global unicast address(es):
Ipv6 Global Address
2000:0DB8::2/64 (ANY)
Type
Manual
OL-32830-01 Command Line Interface Reference Guide
IPv6 Commands