Logging Aggregation On - Cisco 300 Series Cli Manual

SYSLOG Commands
OL-32830-01 Command Line Interface Reference Guide
Example
The following example configures the VLAN 10 as the source interface.
switchxxxxxx(config)#

49.12 logging aggregation on

To control aggregation of SYSLOG messages, use the logging aggregation on
Global Configuration mode command. If aggregation is enabled, logging
messages are displayed every time interval (according to the aging time specified
by logging aggregation
messages, use the no form of this command.
Syntax
logging aggregation on
no logging aggregation on
Parameters
This command has no arguments or keywords.
Default Configuration
Enabled.
Command Mode
Global Configuration mode
Example
To turn off aggregation of SYSLOG messages:
switchxxxxxx(config)#
logging source-interface-ipv6 vlan 100
aging-time). To disable aggregation of SYSLOG
no logging aggregation on
49
964