Lldp Run; Lldp Receive - Cisco 300 Series Cli Manual

Link Layer Discovery Protocol (LLDP) Commands
OL-32830-01 Command Line Interface Reference Guide
Command Mode
Interface (Ethernet) Configuration mode
Example
switchxxxxxx(config)#

30.17 lldp run

To enable LLDP, use the lldp run Global Configuration mode command. To disable
LLDP, use the no form of this command.
Syntax
lldp run
no lldp run
Parameters
This command has no arguments or keywords.
Default Configuration
Enabled
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)#

30.18 lldp receive

To enable receiving LLDP on an interface, use the lldp receive Interface (Ethernet)
Configuration mode command. To stop receiving LLDP on an Interface (Ethernet)
Configuration mode interface, use the no form of this command.
lldp optional-tlv 802.1 protocol add stp
lldp run
30
660