Cdp Log Mismatch Duplex - Cisco 300 Series Cli Manual

8
207
User Guidelines
Use the cdp source-interface command to specify an interface whose minimal IP
address will be advertised in the TVL instead of the minimal IP address of the
outgoing interface.
Example
switchxxxxxx(config)#
8.8

cdp log mismatch duplex

Use the cdp log mismatch duplex Global and Interface Configuration mode
command to enable validating that the duplex status of a port received in a CDP
packet matches the ports actual configuration. If not, a SYSLOG duplex mismatch
message is generated. The no format of the CLI command disables the generation
of the SYSLOG messages.
Syntax
cdp log mismatch duplex
no cdp log mismatch duplex
Parameters
N/A
Default Configuration
The switch reports duplex mismatches from all ports.
Command Mode
Global Configuration mode
Interface (Ethernet) Configuration mode
Example
switchxxxxxx(config)#
switchxxxxxx(config-if)#
cdp source-interface gi11
interface gi11
cdp log mismatch duplex
OL-32830-01 Command Line Interface Reference Guide
CDP Commands