Show Ports Security Addresses - Cisco 300 Series Cli Manual

5
185
Port Status Learning
------- -------- ---------
gi11 Enabled
gi12 Disabled
gi13 Enabled
The following table describes the fields shown above.
Field Description
Port The port number.
Status The port security status. The possible values are:
Enabled or Disabled.
Action The action taken on violation.
Maximum The maximum number of addresses that can be
associated on this port in the Max-Addresses mode.
Trap The status of SNMP traps. The possible values are:
Enable or Disable.
Frequency The minimum time interval between consecutive
traps.

5.34 show ports security addresses

To display the current dynamic addresses in locked ports, use the show ports
security addresses Privileged EXEC mode command.
Syntax
show ports security addresses
Parameters
•
interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or port-channel.
•
detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Action Maximum Trap
------ --- -------
Max- Discard
Addresses
Max- -
Addresses
Lock Discard
[interface-id | detailed
OL-32830-01 Command Line Interface Reference Guide
Address Table Commands
Frequency
--------
3 Enabled 100
28 - -
8 Disabled -
]