Tacacs-Server Key - Cisco 300 Series Cli Manual

TACACS+ Commands
OL-32830-01 Command Line Interface Reference Guide
Syntax
tacacs-server host source-interface-ipv6
no tacacs-server host source-interface-ipv6
Parameters
•
interface-id
—Specifies the source interface.
Default Configuration
The IPv6 source address is the IPv6 address defined on the outgoing interface
and selected in accordance with RFC6724.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the source IPv6 address is an IPv6
address defined on the interfaces and selected in accordance with RFC 6724.
If the source interface is not the outgoing interface, the source IPv6 address is the
minimal IPv6 address defined on the source interface and matched to the scope
of the destination IPv6 address is applied.
If there is no available source IPv6 address, a SYSLOG message is issued when
attempting to communicate with an IPv6 TACACS+ server.
Example
The following example configures the VLAN 10 as the source interface.
switchxxxxxx(config)#

51.4 tacacs-server key

To set the authentication encryption key used for all TACACS+ communications
between the device and the TACACS+ daemon, use the tacacs-server key Global
Configuration mode command. To disable the key, use the no form of this
command.
interface-id
tacacs-server host source-interface-ipv6
51
vlan 100
1000