Bridge Multicast Ipv6 Ip-Address - Cisco 300 Series Cli Manual

Address Table Commands
OL-32830-01 Command Line Interface Reference Guide
5.10

bridge multicast ipv6 ip-address

To register an IPv6 Multicast address to the bridge table, and statically add or
remove ports to or from the group, use the bridge multicast ipv6 ip-address
Interface (VLAN) Configuration mode command. To unregister the IPv6 address,
use the no form of this command.
Syntax
bridge multicast ipv6 ip-address
interface-list |
port-channel port-channel-list}]
no bridge multicast ipv6 ip-address
Parameters
•
ipv6-multicast-address—Specifies the group IPv6 multicast address.
•
add—(Optional) Adds ports to the group.
•
remove—(Optional) Removes ports from the group.
•
interface-list
ethernet
Separate nonconsecutive Ethernet ports with a comma and no spaces; use
a hyphen to designate a range of ports.
•
port-channel port-channel-list
Separate nonconsecutive port-channels with a comma and no spaces. Use
a hyphen to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
To register the group in the bridge database without adding or removing ports or
port channels, specify the ipv6-multicast-address parameter only.
Static Multicast addresses can be defined on static VLANs only.
ipv6-multicast-address [[add | remove] {ethernet
ip-multicast-address
—(Optional) Specifies a list of Ethernet ports.
—(Optional) Specifies a list of port channels.
5
154