Permit ( Ipv6 ) - Cisco 300 Series Cli Manual

ACL Commands
OL-32830-01 Command Line Interface Reference Guide
switchxxxxxx(config-ip-al)#
4.5

permit ( IPv6 )

Use the permit command in Ipv6 Access-list Configuration mode to set permit
conditions (ACEs) for IPv6 ACLs. Use the no form of the command to remove the
access control entry.
Syntax
protocol {any | { source-prefix/length}{any | destination- prefix/length}
permit
[ priority][dscp number | precedence number] [
ace-priority
time-range-name]
[log-input]
permit icmp {any | {source-prefix/length}{any | destination- prefix/length}
{any| i cmp-type} {any| i cmp-code} [
number] [ time-range
[log-input]
{any | {source-prefix/length} {any | source-port/port-range}}{any |
permit tcp
destination- prefix/length} {any| destination-port/port-range} [
priority][dscp number | precedence number] [match-all list-of-flags] [
time-range-name]
[log-input]
permit udp {any | {source-prefix/length}} {any | source-port/port-range}}{any |
destination- prefix/length} {any| destination-port/port-range} [
priority][dscp number | precedence number][
[log-input]
protocol {any | { source-prefix/length}{any | destination- prefix/length}
no permit
[dscp number | precedence number] [
[log-input]
no permit icmp {any | {source-prefix/length}{any | destination- prefix/length}
{any| i cmp-type} {any| i cmp-code} [dscp number | precedence number] [
time-range-name]
[log-input]
permit tcp 2001:0DB8:0300:0201::/64 any any 80
ace-priority
time-range-name]
time-range
time-range
priority][dscp number | precedence
ace-priority
ace-priority
time-range-name]
time-range
time-range-name]
4
time-range
time-range
120