Hobart 9OC24S Operation Manual page 72

FOBART
I
t
QD
:MOTOR GENERATOR DIVISION
2
"0
z
HOBI\RT BROTHERS COMPANY
b . I) ,&'
OPERATION, MAINTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC. NO. 5381A
(6) When nuts are tightened, move to the cable box and pull on the cable assembly
slightly so that the cable falls in a gentle arc from the terminal board to the
cable clamps. Position clamps over cable and install screws removed in step (3)
above . Tighten screws securely but not enough to cause the clamp to damage
the cable insulation.
(7) Remove the wooden block from the plug box (see Fig. 3). Coil the cable
into the cable box and place the cable plug connector in the plug box.
NOTE: (a) Plug b ox may be located outside the cable box on some units.
(b) When an output cable is not supplied with the generator set,
a wooden block is placed in the plug box at the factory to
allow the machine to be operated in DRIVE mode until a
cable assembly is installed.
B. Transformer-Rectifier Output Cable Installation
(1) Install DC output cables as illustrated in Fig. 4. Use 4/0size cables.
(2) Remove wooden block from cable plug box (see Fig. 5) and place cable con-
nector in plug box. Stow cable on cable rack.