Hobart 9OC24S Operation Manual page 258

GENERATOR DIVISION
HOBIRT BROTHERS COMPANY
OPERATION, MAINTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELlED GENERATOR SET, SPEC. NO. 5381A
CAUTION: IF THE VEHICLE IS NOW TO BE MOVED BY TOWING OR
PUSHING, REMOVE THE DRIVE SHAFT.
3.
lnsta llation
A. Preparation for Installation
(1) Location
If the vehicle chassis was moved or stored away from the location where the
engine-generator was removed, it must be re-located in a clean, clear area
where lifting equipment is available.
Move everything required (canopy,
transmission, etc.) into the assembly area. Check all parts and assemblies
to be sure everything required for assembly is available, in good condition,
and ready for assembly.
(2) Equipment required
Tools and equipment required for installation are the same as those listed in
Para. 2, A, (2) above.
B.
Installation Procedures
(1) Install clutch and transmission
It is much easier to install the clutch and transmission while the engine-generator
assembly is removed from the vehicle.
(a) Position clutch disc and clutch cover on the exciter flywheel. Use a clutch
alignment tool to align clutch disc splines with pilot bearing in the end of
the exciter shaft.
(b) Align cover mounting holes and install cap screws. Tighten screws a little
at a time, alternating from screw to opposite screw until all screws are
securely tightened.
(c) Install transmission
by
guiding the end of the main shaft
through
the splined
clutch huband into the pilot bearing.
NOTE: If the clutch huband pilot bearing are not in alignment, it may
be necessary to loosen the clutch cover screws to allow the clutch
disk to move slightly and align with the pilot bearing. Retighten
clutch cover screws secure ly .
(d) Install transmission attaching cap screws securely.
4-l
Page 10
Ott 3w3