Accelerator Linkage Adjustment; Clutch Pedal Adjustment - Hobart 9OC24S Operation Manual

GENERATOR DIVISION
HOBART BROTHERS COMPANY
OPERATION, MAINTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC:.NO. 538iA
To accelerator
pedal
3
Hydraulic
Actuator
1. Actuator arm 5. Guide yoke
2. Finger 6. Locknut
3. Locknuts 7. Cable core
4. Extension rod 8. Cable housing
Accelerator Linkage Adjustment
Figure 13
(3) To adjust clearance, loosen locknut (6) and either thread extension rod (4)
farther onto the core (7), or back it off, as required to reposition finger (2)
to obtain a clearance (A) of l/16 to l/8 inch between arm (1) and finger (2).
NOTE: Nut (6) must be tight against finger (2) when checking clearance.
(4) Operate arm (1) throughout its full travel to make certain it will not touch any
' component inc Iuding finger (2).
(5) Check security of all components.
4. Chassis Comoonents Adiustment
Since mobile operation is limited (mileagewise) for this unit, wear and adjustment of
chassis parts should be minimal. Adjustments most like ly to be required are covered here.
A. Clutch Pedal Adjustment
The clutch pedal adjustment should be checked at once when the clutch does not
'
engage or disengage properly, or when transmission gears are difficult to engage.
An improperly adjusted clutch linkage can cause slippage and complete clutch
failure.
(1) Check clutch pedal adjustment (see Fig. 14).
,- - - ._ -r
~~~.-__
2-3 - --
-Pagei%l----
____