Hobart 9OC24S Operation Manual page 253

YOBART
I
"0
QD
gMOTOR GENERATOR DIVISION
a
:
2
HOBPIRT BROTHERS COMPANY
4,
Q. I,l\ k++
OPERATION, MANTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELLED GENERATOR SET', SPEC. NO. 5381A
Steering Gear
Figure 3
(14) Disconnect all leads, controls, and instruments which could prevent removal
of the rear canopy and control box assembly. Remove cable ties and clamps
as required.
NOTE: Identify and mark all leads disconnected, so that they may be
properly reconnected.
(a) Disconnect all stator leads at terminal board cn right side of unit.
(b) Disconnect all 12-V DC leads at protective devices (low oil pressure,
temperature, etc. ).
(c) Disconnect 12-V DC voltage regulator leads at regulator.
(d) Disconnect hydraulic actuator and governor control box leads as required.
(e) Disconnect all vehicular light leads at terminal boards (Ref. 3-2, Fig. 3)
as required.
(f) Disconnect instruments (heat indicator, oil gage, etc.).
act 30/73
- - .-_----
: 4-l
___-
Page 5
--,