Hobart 9OC24S Operation Manual page 263

GENERATOR DIVISION
HOBART BROTHERS COMPANY
OPERATION, MAINTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC. NO. 5381A
SECTION 2. INDIVIDUAL COMPONENTS REMOVAL AND INSTALLATION
1. Genera I
Most components of the self-propelled generator set are removable and replaceable with-
out special instruction.
Before removing any assembly or unit, observe and note the mounting arrangement, the
routing of any connecting parts and wiring, and the terminal location of input and out-
put leads.
Use good mechanical and electrical practices in both removal and installation. Do not
use undue force to remove or instal I components.
Refer to Chapter 7 for illustrations of components and their relation to each other. Re-
fer to connection diagrams in Chapter 5 for complete wiring details.
2.
Generator Control Box Trays
The three trays mounted in the generator control box are designed for quick and easy
removal and installation. All trays are removed in a similar manner.
A. Removal
(1) hscrew hex head, captive fasteners (2, Fig. 1) and pull tray outward.
(2) Unscrew serrated nut on Amphenol connector (3) and disconnect.
( (3) Press both tray latches (1) d own and hold in released position. Slide tray
out of control box.
CAUTION: SOME TRAY ASSEMBLIES ARE RATHER HEAVY. DO NOT
DROP.
B. Installation
(1) Position tray in front of proper tray opening and carefully insert side rails
(4) in control box tracks (5).
(2) Press the tray latches (1) down and push tray in beyond latched position.
Release latches and make certain both function properly to limit outward
trave I of tray.
(3) Connect Amphenol connector plug to receptacle and tighten nut.
(4) Push tray inward and secure with captive screw fasteners (2).
Ott 30/73
4-2
Page 1