Hobart 9OC24S Operation Manual page 264

GENERATOR DIVISION
HOBI\RT BROTHERS COMPANY
OPERATION, MAINTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC. NO. 5381A
1. Latch
2. Fastener
3. Connector
4. Rail
5. Track
Control Tray Removal (Typical)
(Voltage Regulator Tray Illustrated)
Figure 1
3.
Power Module Panel Assemblv
A. Removal
(1) Remove plastic cover (4, Figure 2) by removing two attaching screws.
(2) Remove attaching nuts and disconnect three output leads (5) from load con-
tactor (9).
(3) Disconnect the lower group of outgoing leads (6) from terminal board (7).
(4) Remove three terminal nuts (1). Remove two nuts and washers which attach
cable clamps (3). (These are also panel attaching nuts.) With generator
cables (2) thus loosened, pull them off terminal studs (10).
4-2 - - - - _.__ _ _..
Ott 30/73
_. ~.._._ -- .- .-.
_. _ -. -._---_.
Page 2
- -
- - - _ _ _