Hobart 9OC24S Operation Manual page 110

GENERATOR DIVISION
HOBART BROTHERS COMPANY
OPERATION, MAINTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC. NO. 5381A
Maintain at least 1 (one) inch free clutch pedal travel. Adjust as required
in accordance with instructions in 2-3, Para. 4, A, (2).
(4) Brakes
(a) Brake pedal trave I
t Maintain at least l/4 inch free brake pedal travel. Adjust as required.
See 2-3; Para. 4, B.
(b) Brake shoe adjustment
Adjust brake shoes in accordance with 2-3, Para. 4, D, anytime pedal may
be depressed over halfway to the floor board when applying brakes.
(5) Steering
Check the following anytime vehicle is raised for service.
(a) Check steering linkage for looseness.
Correct as required by adjustment or
replacement of parts.
(b) Check gear box for excessive lash by turning steering wheel while observing
front wheels. Any movement of the steering wheel should cause a move-
ment of the front wheels. Adjust gear box as required.
(6) Chassis
(a) Front whee I bearings
Check front whee I bearings when the vehicle is raised for service of any
kind.
(aa) Alternately pul I outward, and push inward on the tire at points near
the floor. If looseness is found, make certain it is not in the spindle
and bushings by observation.
(bb) If any looseness in the bearings is felt, adjust to eliminate looseness.
DO NOT OVERTIGHTEN.
(cc) Be CERTAIN hub nut cotter pins are installedsecurely.
C.
"A" Checks and Operations (10 Hours or Daily)
(1) Engine
2-l . ~. ~,~
.~ Ott 30/73
Page 6