Hobart 9OC24S Operation Manual page 259

(2)
Raise the chassis and support with iack stands or blocks as instructed in Para.
2, A,
(2).
(3)
(4)
(5)
Attach lifting hoists to the engine-generator as instructed in Para. 2, B, (28).
Lift the assembly and make certain all lifting components are dependably secured.
Move the assembly to a position above its mounted location in the chassis.
Lower the assembly slowly and guide it into mounted position.
CAUTION: GUIDE AND STEADY THE ENGINE-GENERATOR ASSEMBLY
CONSTANTLY. BE SURE THAT THE ASSEMBLY IS CLEAR
AT ALL TIMES AND THAT ITEMS SUCH AS THE CLUTCH
SHAFT ARE NOT DAMAGED.
(6)
Shift the assembly as required to align mounting holes, etc.
Install front
engine support screws and generator-to-frame attaching screws.
(7)
(8)
(9)
(10)
(11)
Install drive shaft.
Position the pedal assembly (2, Fig. 6) and attach with two screws (1).
Connect two brake tubes to master cylinder fitting (Ref. 3, Fig. 5).
Connect stoplight switch and Micro switch leads (1 and 2, Fig. 5).
Position bearing (6, Fig. 4) on bracket (7). Attach with two screws, nuts,
and washers.
* (12)
(13)
(14)
(15)
Ott 30/73
Connect clutch rod (2, Fig. 4) to clutch pedal. It may be necessary to slide
the peda I partly off of the shaft to make this connection. Ref. Para. 2, B,
(20). Install washer and new cotter pin (1).
Hoist radiator into position and attach.
Connect all coolant hoses and tighten clamps securely.
Attach a hoist to the control box assembly and carefully lift into position.
Route cables, leads, controls, etc.,
so that they are properly positioned and
not pinched or damaged.
Align mounting holes and install attaching screws.
Remove hoist.
4-l
Page 11
FOBART
8
I
QD
gMOTOR GENERATOR DIVISION
i
HOBART BROTHERS COMPANY
"c
b . B ,+*
OPERATION, MAINTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC. NO. 5381A