Hobart 9OC24S Operation Manual page 266

FOBART
:
t
QQ
iMOTOR GENERATOR DIVISION
a
HOBART BROTHERS C0MPP.N"
"0
2
% . B ,8
OPERATION, MAINTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC. NO. 5381A
(5) Remove nuts (8) and washers and lift off power module panel assembly.
B. Installation
(1
(2
(3)
(4)
(5)
(6)
Position the power module panel assembly on the four mounting studs, and
attach with two washers and nuts (8) on left side.
Be sure capacitor (11) leads are connected to terminals (lo), and place
generator lead terminals on studs (10). Position cable clamps (3) on pane I
mounting studs and secure with panel mounting nuts. Install nuts (1).
Connect leads (6) to terminal board (7). Refer to connection diagram in 5-l
if necessary.
Connect output cables (5) to load contactor (9).
Check all attaching parts for security.
Install cover (4) with two attaching screws.
4. Control Box
A. Removal
The control box and rear canopy are removable as an assembly.
It is unlikely that
the box will be removed except to accomplish engine-generator removal.
Remove the box assembly in accordance with applicable portions of 4-1, Para. 2, B.
B.
lnstal lation
Install the control box assembly in accordance with applicable portions of 4-1, Para.
3, B.
4-2
Page 4