Hobart 9OC24S Operation Manual page 182

_
_J
.-"
GENERATOR DIVISION
HOBART BROTHERS COMPAN"
OPERATION, MAIN.TENANCE.,_AND OVERHAUL MANUAL, TM-240A ..I-..'. ,
SELF-PROPELLED GENERATOR SET, SPEC. NO. 5381A
1. Connector
2. Magnetic pickup
3. Nut
Magnetic Pickup Adiustmen t
Figure 10
(3) Hydraulic actuator adjustment
This operation is designed to confine all testing and adjusting to the actuator
alone, and to eliminate the influence of any governor problems outside the
actuator.
The operation actually becomes a simulated bench test.
The actuator has one adjustment which determines the voltage values required
to correctly position the output shaft (and lever) throughout its operating range.
This adjustment is controlled by an adjusting screw (3, Fig. ll), located in the
bottom of the actuator body.
To test and adjust the actuator on the engine,
proceed as follows:
(a)
If accelerator I inkage is not already taken off, remove as instructed in
Para. 3, E, (l), (a)above.
(b) Start engine and operate at idle speed. With the operating mode control
switch in DRIVE position, the actuator will be receiving NO signal from the
control box.
--- -_' -~----_- .- .--. ..-_ _-__-.__
..~ -_. ._..
2-3 I
-- ---!
Page 24
.-- ._ __----___
Ott
--._---__- -. _ _ _. _ .---
30/73:
i