Hobart 9OC24S Operation Manual page 252

_.
HOBART
P
z
QQ
;MOTOR GENERATOR DIVISION
'0
d
HOBART BROTHERS COMPAN"
9 0. B&1.1\
d
OPERATION, MAINTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC. NO. 5381A
Accelerator Control Cable Connection
Figure 2
(11) Remove lower canopy side panels (8, Fig. 1) on both sides.
(12) Remove turn signal control from steering column. Disconnect horn wire.
(13) Note the position of steering whee I spokes when front whee Is are pointing
straight ahead (for future installation of steering column). Support steering
column and remove steering column clamps.
screw in lower steering column "U"
Loosen spl ined joint clamping
joint (2) and slide joint off steering
gear box shaft.
Lift the complete steering column out.
4-l
Ott 30/73
..Pw 4
. -_ - ._ _ - - _- _