Hobart 9OC24S Operation Manual page 197

rOBAR<
B
z
QB
;MOTOR GENERATOR DIVISION
:
"0
5
HOBART BROTHERS COMPAN"
b. ,,J
OPERATION, MAIN ENANCE , AND OVERHAUL MAN UAL, ~~-240~
SELF-PROPELLED GENERATOR SET, SPEC. -NO. 5381A
(g) Repeat the bl ee mg operation at the other wheel cylinders in the follow- d'
ing order: left front, right rear, and left rear.
(h) Close bleeder tank valve and remove brake bleeding equipment.
(i) Be sure master cylinder is filled.
Install filler cap and access cover,
and lower vehicle.
F. Gearshift Micro Switch Adjustment
Improper adjustment of this switch could cause the engine to stop when the
generate-drive switch is placed in GEN position. Check and adjust the switch
as follows:
(1) Remove floorboard.
(2) Place gearshift lever (Figure 19, item 2) in NEUTRAL position, and check
the relative positions of Micro switch button (6) and trip arm (1). The switch
actuating button (6) should extend from the switch (4) to its full ON position
and be located in the trip arm notch (7). If the switch is out of position,
proceed to step (3).
(3) Loosen nuts (5) and screws (3) sufficiently to allow screws to move in adjusting
slots provided in the mounting bracket (8).
(4) Move the switch (4) away from the trip arm (1) until button (6) is free of the
arm.
, (5) Reposition switch (4) so that button
(6) is located in the notch (7), but not
touching .
(6) Tighten nuts (5) and screws (3). Check the adjustment by observing trip arm
(1) and switch button (6) action when the gearshift lever (2) is moved into a
gear selection position .
Cam action of the trip arm should actuate the switch
button to open switch contacts, and allow the button to return to ON position
when the lever is placed in neutral.
(7) Replace floorboard.