Hobart 9OC24S Operation Manual page 71

yOBAR1
I
I
QD
iMOTOR GENERATOR DIVISION
2
"0
z
HOBART BROTHERS COMPAN"
b. *,,+++
OPERATION, MAINTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC. NO. 5381A
1.
2.
3.
Engine Oi I Gage Rod and Filler Cap
Figure 1
Oil level gage rod
Oil filler cap
Left valve cover
NOTE: Conductor size recommended for AC output is 2/O size. Use No.
12 size for control (E and F terminals).
Large cables (A, B, C, N) should be equipped with terminals
having at least a 3/8-inch diameter mounting hole. Mount-
ing hole in small leads (E and F) should be at least l/4-inch
diameter.
(4) Push approximately l-1/2 feet of cable through the hole so that cable ends
will easily reach the terminal panel.
(5) Work through the opening behind the seat back to attach the cable terminals
to the output terminal panel. Each terminal stud is identified by an identifica-
tion plate. Each cable of the cable assembly is identified by a band-type
marker. Remove terminal nuts and connect cable "A" to terminal "A", "B"
to "B", etc.
install terminal nuts and tighten securely.
--- - __--.__ ------ .- ---... -- _-._
Ocf 3@3_- .-~ .- -.---.. __.~ -_ ..--- __-_ - -..- ~~...~ ..-- ~.-.-..-- _- -
- - - - --.~. --~~
_-__- __._ -.-._ - __
_
l-2
Page 3