Hobart 9OC24S Operation Manual page 119

FOBART
I
I
QD
;MOTOR GENERATOR DIVISION
2
"0
z
HOBART BROTHERS COMPANY
B . B ,,+"
OPERATION, MAINTENANCE, AND OVERHAUL'MAN UAL, TM-240A
SELF-PROPELLED GENERATOR SET, WC. NO. 5381A
(i) Check alternator and cranking motor
The alternator and cranking motor on this particular engine require no
periodic lubrication.
See 2-2, Para. 2, E, (1) and (2) for details.
(2) Drive train
(a) Check universal joints for looseness.
(b) Check security of drive shaft attaching hardware.
(c) Check rear axle nuts to be sure they are tight.
(d) be certain cotter pins are installed.
(3) Steering
Check steering gear and linkage for excessive looseness.
(a) Raise the front end of the vehicle , so the front whee Is are off the floor.
(b) Turn the steering wheel while observing the front wheels. Any movement
of the steering wheel should result in a movement of the front wheels.
(c)
If f ron w ee s
t h
I d o not respond at once to a movement of the steering
whee I, adjust steering gear.
(4) Chassis
(a) Front whee I bearings
Check front wheel bearings as follows:
(aa) Raise front end of vehicle until front wheels are off of the floor.
(bb) Alternately pull outward, and push inward on the tire at points near
the floor. If looseness is found, make certain it is not in the spindle
and bushings by observing spindle and axle while checking the
whee I.
(cc) If looseness in the bearings is felt, adjust bearings. DO NOT
OVERTIGHTEN.
(dd) Be CERTAIN hub nut cotter pins are insta lled securely.
act 30/73
_.
2-l
_ .,. .-..
--Page. 15