Hobart 9OC24S Operation Manual page 60

_
HOBART _I
"c
:,
t
QD
;MOTOR GENERATOR DIVISION
:
E
HOBART BROTHERS COMPANY
% . II ,,B
OPERATION, MAINTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC:NO. '5381A
-
of another potentiometer (3). Cable compensation may be turned ON or
OFF by a toggle switch (5). For this application the switch must always
be ON. An instruction plate under the potentiometer knobs indicates
proper setting for various cable sizes and lengths. Regulator stability
is adjusted by the damping circuit gain potentiometer (8). Regulator
response time is adjusted by the damping circuit rate potentiometer (10).
(9) Power module panel assembly (See Fig. 10)
The power module assembly, sometimes referred to as the "contactor panel",
is located on the back panel of the control box. Components of the power
module panel assembly are as follows:
(a) Capacitors
The function of the three capacitors (10, Fig. lo), which are connected
to the generator output leads at the bus bar terminals, is to eliminate
radio frequency interference before it is transmitted along the 400-Hz
output cables.
1. Tray
2. Voltage regulator
3. Nylon roller
4. Fastener
Voltage Regulator Tray