Hobart 9OC24S Operation Manual page 250

YOBARI
z
"0
QD
gMOTOR GENERATOR DIVISION
f
:
2
HOBART BROTHERS COMPANY
%
*. 8,1~p'
OPERATION, MAINTENANCE, AND OVERHAUL MANUAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC. NO. 5381A
WARN IN G:
IF WHEELS ARE PLXED ON WOODEN BLOCK, BE SURE THEY
ARE CHOCKED SECURELY. IN ALL CASES MAKE CERTAIN
THE VEHICLE CANNOT SLIP OR FALL. DO NOT DEPEND
UPON THE PARKING BRAKE TO HOLD THE VEHICLE ON
WOODEN BLOC KS.
(3) Open hinged-folding doors (3, Fig. 1) on each side of the vehicle and remove
left access cover (5) by removing eight screws. Remove control box cover by
removing six attaching screws.
(4) Drain the cooling system.
Provide floor pans for catching coolant.
(5) Open battery access doors (7) and disconnect both the positive lead and ground
lead terminals for extra safety. Close doors.
(6) Disconnect the battery positive lead at the starter solenoid.
(7) Close the fuel tank shut-off valve (Ref. l-l, Fig. 3, item 14), located on the
right side of the vehicle and disconnect both the fuel delivery and return hoses.
(8) Remove floorboard as follows:
(a) Remove gearshift lever knob.
(b) Remove four attaching screws and lift off gearshift lever boot. Reinstall
knob.
(c) Use a floor creeper to gain access to the underside of the floorboard, and
disconnect the accelerator control cable (3, Fig. 2) from lever (1) by
removing cotter pin (2) and straight, headed pin (5). Loosen nut (4) and
slide the cable assembly out of the bracket (6).
(d) Remove sixteen attaching screws and lift out the floorboard assembly.
(Apply the parking brake so that the floorboard will clear the lever.)
(9) Remove attaching screws and lift off canopy top and doors.
(10) Disconnect front clearance light leads at quick disconnects, and remove front
canopy (1, Fig. 1) attaching screws.
Remove exhaust pipe elbows (if used) and
lift off front canopy.
4-l
Page 2
Ott 30/73