Hobart 9OC24S Operation Manual page 160

FOBART
D
2
QD
EMOTOR GENERATOR DIVISION
0
:
z
HOBART BROTHERS COMPANY
a
b. a,'\~e
OPERATION, MA IN TEN AN CE , AND OVERHAUL MAN-UAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC. NO. 5381A
Governor Control
Box \
Generator Control Box Interior
Figure 1
(11) Check engine circuit fuse (10, Fig. 2) by placing panel light switch (23) in
ON position. If pane I lights (3) operate, the fuse (lo), switch (23) and lamps
'are good.
(12) Check fault indicating lights (35) by pressing lens holders. If lights glow, fuse
(36) and indicating lamps are good.
(13) Check operation of all vehicular lights.
(14) Make a general inspection of all wiring, and terminals. Inspect the equipment
to be certain no damage will result from starting.the engine.
; (15) At initial start-up after generator overhaul or repair, "flash" the exciter field
by momentarily applying 12-V DC to the field windings as follows:
(a) Flashing exciter field using test box /
I
I
!
If a test box (Ref. l-3, Fig. 8) is available, connect it to receptacle
connector (19, Fig. 2).
-_I..__--
_--_-_
2%
L .__.___._ -.--_-- -___-__- ~__
Ott 30/73 :
-~--_~-
______ __ ._ _ _ - ____..
;
Page 2
-A __ _.--_-_-- -.- -