Hobart 9OC24S Operation Manual page 133

HOBART
0
z m
"0
QD
;MOTOR GENERATOR DIVISION
c
d
HOBART BROTHERS COMPAN"
4/
*. *,I\ 8
OPERATION, MAIN TENAN CE , AND OVERHAUL MAN UAL, TM-240A
SELF-PROPELLED GENERATOR SET, SPEC. NO. 538iA
(2)
(3)
(4)
Starter
Most starting motors are lubricated at assembly and should be relubricated
only when the starter is removed and disassembled, however, INSPECT the
starter to make certain it has no lubrication points.
Water pump
To lubricate the water pump, remove pipe plug (see Fig. 7) and replace with
a pressure type lubrication fitting.
Lubricate each 1200 hours with approximately
1 tablespoon of MIL-G-3545 (or equivalent) grease.
CAUTION: DO NOT OVERLUBRICATE. PUMP SEALS WILL BE DAMAGED
BY OVER LUBR ICATION.
Fan hub
Lubricant in the fan hub should be checked after each 1200 hours of operation
or yearly. The fan hub on this particular engine is lubricated with grease.
The hub is equipped with a pipe plug instead of a lubrication fitting to dis-
courage and/or prevent overlubrication which could damage internal seals.
Lubricate as follows:
PIPE
PLUG
Water Pump Lubrication
Figure 7