Table of Contents
Advertisement
Chapter 45. Message Filter Action configuration mode
This chapter provides an alphabetic listing of commands that are available in
Message Filter Action configuration mode.
To enter this configuration mode, use either the Global monitor-action command.
While in this mode, define a filter action. This action enables the configuration of
control procedures. A filter action is an action or set of actions to implement when
a monitored message class exceeds a configured threshold value.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Message Filter Action configuration
mode.
block-interval
Specifies the time period during which a message class is denied service as a
consequence of exceeding a configured threshold.
Syntax
block-interval milliseconds
Parameters
milliseconds
Guidelines
This command is meaningful only if the type command is set to block, and is
otherwise not used.
This command is required when the type command is set to block.
Related Commands
log-priority, type
Examples
v Enters Message Filter Action configuration mode to create the Squelch control
v Specifies a block interval of 2½ seconds.
© Copyright IBM Corp. 1999, 2008
Specifies the blackout in milliseconds.
procedure.
# monitor-action Squelch
Message filter action Configuration mode
#
# type block
# block-interval 2500
#
421
Advertisement
Table of Contents
