Table of Contents
Advertisement
Parameters
size
Guidelines
Operations greater than 8192 bytes should only be used with TCP as the
transport-layer protocol.
Related Commands
read-only, transport, wsize
timeo
Specifies the initial interval between an RPC minor time out and a subsequent
retransmission attempt.
Syntax
timeo seconds
Parameters
seconds
Guidelines
Used in conjunction with the retrans command to specify behavior in response to
RPC minor time outs and subsequent retransmission attempts.
The retrans command specifies the number of RPC minor time outs that are
tolerated per NFS transaction before an NFS read or write error is declared. The
timeo command provides a base value to determine the interval between the RPC
time out and the subsequent retransmission attempt.
For example, assuming default values (3 for retrans, and 0.7 seconds for timeo),
RPC time outs are dealt with as follows.
1. In response to the first RPC time out, the appliance waits 0.7 seconds and then
2. In response to the second RPC time out, the appliance doubles the initial time
3. In response to the third RPC time out, the appliance doubles the previously
4. In response to the fourth time out, which is greater than the value specified by
The interval between RPC time outs and a subsequent retransmission will never
exceed 6 seconds.
Related Commands
retrans
500
Command Reference
Specifies the number of bytes in each NFS read operation. Use an integer
in the range of 1024 through 32769. The default is 4096.
Specifies the interval in tenths of a second between an initial RPC time out
and the subsequent retransmission by the appliance. Use an integer in the
range of 1 through 60. The default is 7.
retransmits.
out value to 1.4 seconds and then retransmits.
used time out value to 2.8 seconds and then retransmits.
the retrans command, the appliance declares an NFS read or write error.
Advertisement
Table of Contents
