Table of Contents
Advertisement
Chapter 10. CRL configuration mode
This chapter provides an alphabetic listing of commands that are available in CRL
configuration mode. CRL is the abbreviation for Certificate Revocation List.
To enter this configuration mode, use the crypto crl command. While in CRL
configuration mode, define the CRL update policy to enable the scheduled retrieval
of CRLs with either LDAP or HTTP as a retrieval mechanism.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in CRL configuration mode.
bind-dn
Specifies the login DN (distinguished name) used to access an LDAP server.
Syntax
bind-dn dn
Parameters
dn
Guidelines
You must specify a login DN when defining LDAP-enabled CRL Update Policy.
Related Commands
bind-pass, read-dn, refresh, remote-address
Examples
v Enters CRL Mode to create the LDAP1440 LDAP-enabled CRL Update Policy. The
bind-pass
Specifies the password to access an LDAP server.
Syntax
bind-pass password
Parameters
password
© Copyright IBM Corp. 1999, 2008
Specifies the login name to access the target LDAP server.
LDAP server is accessed with the account name of X with a password of
1PAss$WorD.
# crl LDAP1440 ldap
Entering CRL mode for 'LDAP1440'
# bind-dn X
# bind-pass 1PAss$WorD
#
Specifies the password for the login DN.
207
Advertisement
Table of Contents
