Table of Contents
Advertisement
Chapter 58. Policy Parameters configuration mode
This chapter provides an alphabetic listing of commands that are available in
Policy Parameters configuration mode.
To enter this configuration mode, use the Global policy-parameters command.
Many of the commands that are listed in "Common commands" on page 2 and
most, but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in this configuration mode.
parameter
Defines a policy parameter.
Syntax
parameter name value
Parameters
name
value
Guidelines
The parameter command defines a policy parameter as a key-value pair. The key
specifies the name of a policy parameter that is used in a policy mapping style
sheet. Use this command to defined all required policy parameters that are needed
by the policy mapping style sheet.
A policy parameters is the way that you must map the needed parameters that are
defined in or referenced by the WSDL policy or that are defined in an attached
source to the specific DataPower object. If you do not define all the needed
parameters, processing a message with the defined WS-Policy generates errors.
For example, you might need an X.509 token to use the defined WS-Policy. If you
need an X.509 token, you need to define which certificate that is stored on the
DataPower appliance to use. If the certificate is alice, you would need to set the
{http://docs.oasis-open.org/ws-sx/ws-securitypolicy/200702}ws-secpol-
Certificate parameter to alice.
Note: If you defined a policy parameters at the port or port-operation level, these
© Copyright IBM Corp. 1999, 2008
Specifies the name of the parameter in the {domainNamespace}key format.
Specifies the value for the parameter.
parameters are not applied to its parallel synthesize port or operation. The
policy parameters for synthesized ports and operations must be inherited
from the service level or redefined at the synthesized level.
523
Advertisement
Table of Contents
