Table of Contents
Advertisement
Chapter 13. Crypto Firewall Credentials configuration mode
This chapter provides an alphabetic listing of commands that are available in
Crypto Firewall Credentials configuration mode.
To enter this configuration mode, use the Crypto fwcred command. While in this
configuration mode, you can create a Firewall Credentials list that identifies which
keys and certificates available to a DataPower appliance to support firewall
processing.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Crypto Firewall Credentials
configuration mode.
certificate
Adds a certificate alias.
Syntax
certificate alias
Parameters
alias
Guidelines
Prior to adding a certificate alias to the Firewall Credentials list:
1. Use the copy command (or the WebGUI) to transfer the actual certificate to the
2. Use the Crypto certificate command to create a certificate alias.
Use the no certificate command to delete a certificate alias from a Firewall
Credentials List.
Related Commands
certificate (Crypto)
Examples
v Enters Firewall Credentials mode for the FWCred-1 Firewall Credentials. Adds
key
Adds a key alias.
© Copyright IBM Corp. 1999, 2008
Specifies the alias for the target certificate. The target certificate must be
previously created with the Crypto certificate command.
appliance.
the certificate that is referenced by the alice-3 alias.
# fwcred FWCred-1
Entering Firewall Credentials mode for 'FWCred-1'
# certificate alice-3
#
247
Advertisement
Table of Contents
