Guidelines
The raid-volume-initialize-filesystem command initializes the filesystem on the
hard disk array to allow it to be made active. This action destroys the existing
contents of the hard disk array.
Examples
v Makes a new file system on the raid0 hard disk array volume.
raid-volume-repair-filesystem (Type 9235)
Repairs the file system.
Syntax
raid-volume-repair-filesystem name
Parameters
name
Guidelines
The raid-volume-repair-filesystem command repairs the file system on the hard
disk array, in case it was corrupted by an abnormal shutdown of the appliance or
other error.
Examples
v Repairs the file system on the raid0 hard disk array volume.
rbm
Enters RBM Settings configuration mode.
Syntax
rbm
no rbm
Guidelines
While in RBM configuration mode, you configure role-based management (RBM)
settings.
Use the cancel or exit command to exit RBM configuration mode and return to
Global configuration mode.
Use the no rbm command to disable RBM service. Note that this command can
disable WebGUI access.
# raid-volume-initialize-filesystem raid0
#
Specifies the name of the existing hard disk array volume. For appliances
that have a hard disk array for auxiliary data storage, the name is raid0.
# raid-volume-repair-filesystem raid0
#
Chapter 2. Global configuration mode
81