Chapter 9. Conformance Policy configuration mode
This chapter provides an alphabetic listing of commands that are available in
Conformance Policy configuration mode. To enter this configuration mode, use the
Global conformancepolicy command.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Conformance Policy configuration
mode.
assert-bp10-conformance
Controls the attachment of an assertion to WS-I Basic Profile 1.0 messages.
Syntax
assert-bp10-conformance {on | off}
Parameters
on
off
Guidelines
The assert-bp10-conformance command is meaningful only when validating
messages against WS-I Basic Profile 1.0. The profiles for message validation are
defined using the profiles command. Use the assert-bp10-conformance command
only when the value for the profiles command includes BP10 as part of its
definition.
Related Commands
profiles
Examples
v Disables the attachment of assertions when validating compliance against WS-I
v Enables the attachment of assertions when validating compliance against WS-I
fixup-stylesheet
Identifies which style sheets to invoke after conformance analysis.
© Copyright IBM Corp. 1999, 2008
(Default) Attaches an assertion.
Does not attach an assertion. Use this setting with filter action.
Basic Profile 1.0.
# profiles BP10
# assert-bp10-conformance off
Basic Profile 1.0, which restores the default state.
# assert-bp10-conformance on
197