Table of Contents
Advertisement
After completing the configuration of a count monitor, activate the monitor by
assigning it to a DataPower service.
Related Commands
message-matching (Global), message-type (Global)
Examples
v Specifies the Extranet message class as the target for the LogSquelch count
source
Enables IP address-specific monitoring and information gathering.
Syntax
source {all | ip-each | ip-from-header}
all
ip-each
ip-from-header
Guidelines
The source command is used only if a traffic-flow definition (Message Matching)
contains an ip or ip-exclude command.
In the absence of a source command, source address monitoring and information
gathering (if defined) is aggregated for the entire address range defined by the ip
or ip-exclude commands.
Related Commands
ip (Message Matching), ip-exclude (Message Matching)
Examples
v Enables individualized information gathering for each IP address specified
416
Command Reference
monitor.
# monitor-count LogSquelch
Message count monitor Configuration mode
# message-type Extranet
Specifies that IP source address monitoring and information gathering is
aggregated for the address range defined by the Message Matching ip
command.
Specifies that IP source address monitoring and information gathering is
individualized for all IP addresses (up to 1000) within the range defined by
the Message Matching ip command.
Specifies that IP source address monitoring and information gathering is
individualized for all IP addresses (up to 1000) within the range defined by
the Message Matching ip command. IP addresses are read from the Header
field.
within the traffic-flow definition.
# monitor-count Loose
Message count monitor Configuration mode
# source ip-each
#
Advertisement
Table of Contents
