Table of Contents
Advertisement
v Leaves traditionally-addressed message headers untouched.
wsa-genstyle
Specifies the request-response transmission model between the DataPower service
and the target server.
Syntax
wsa-genstyle { async | oob | sync }
Parameters
async Identifies an asynchronous exchange pattern in which the server response
oob
sync
Guidelines
If the request-response transmission model is async, use the wsa-back-protocol
command to identify the Front Side Protocol Handler to convey asynchronous
server responses to the original requesting clients. For the asynchronous model,
use the wsa-timeout command to specify the maximum time allowed for a server
response.
If the request-response transmission model is oob, ensure that the Web Server
Proxy preserves explicit (non-anonymous), client-originated values for the ReplyTo
and FaultTo elements and passes these values intact to the server.
Related Commands
wsa-back-protocol, wsa-http-async-response-code, wsa-mode, wsa-timeout
wsa-http-async-response-code
Specifies the HTTP response code to send to a client appliance before transmitting
the actual asynchronous server response.
Syntax
wsa-http-async-response-code responseCodeValue
# wsa-force on
#
# wsa-force off
#
or
# no wsa-force
#
is received over a different channel than the one used by the DataPower
service to convey the client request.
Identifies an out-of-band exchange pattern in which the routing of the
response to the original client is handled by the target server and does not
pass through the DataPower service.
(Default) Identifies a synchronous exchange pattern in which the server
response is received over the same channel used by the DataPower service
to convey the client request.
Chapter 49. Multi-Protocol Gateway configuration mode
471
Advertisement
Table of Contents
