Table of Contents
Advertisement
Syntax
undo object-type name
Parameters
object-type
name
Guidelines
The undo command reverts a modified object to its last persisted state. The
persisted state is the configuration in the startup configuration.
If invoked against a modified object in the startup configuration, you will receive
the following message:
If invoked against an new object that has yet to be saved to the startup
configuration, you will receive the following message:
If invoked against a object that has not been modified, you will receive the
following message:
If invoked against a nonexistent named-object, you will receive the following
message:
If invoked against a nonexistent object type, you will receive the following
message:
Related Commands
show, write memory
Examples
v Reverts the modified gateway-1 Multi-Protocol Gateway object to its last saved
urlmap
Enters URL Map configuration mode.
Specifies the type of object. For a complete list of object types, use the
show command
Specifies the name of the object.
objectType name - Configuration reverted.
% Cannot undo new configuration
% Cannot undo - configuration has not been modified
% Cannot undo last configuration change
% Invalid class
configuration.
# undo mpgw gateway-1
mpgw gateway-1 - Configuration reverted.
#
Chapter 2. Global configuration mode
125
Advertisement
Table of Contents
