Table of Contents
Advertisement
Chapter 6. Application Security Policy configuration mode
This chapter provides an alphabetic listing of commands that are available in
Application Security Policy configuration mode.
To enter this configuration mode, use the Global application-security-policy
command. If the policy does not exist, the global command creates the Application
Security Policy. While in this Mode, define the parameters for the Application
Security Policy object.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Application Security Policy
configuration mode.
error-match
Establishes one or more Error Policy Maps for this Security Policy.
Syntax
error-match match-rule processing-rule
no error-match
Parameters
match-rule
processing-rule
Guidelines
Any error condition that matches the configured Match Rule will be handled by
the corresponding Processing Rule. The first Match Rule in the Map that matches
will handle the error. A Security Policy may have no Error Maps, in which case the
Error Map set at the Firewall level (if any) will apply.
Note that either the Web Request Profile or the Web Response Profile invoked to
handle transactions may override this Error Map.
Use the no error-match command to remove the entire Error Map.
Related Commands
error-policy (Web Application Firewall), error-policy-override (Web Request
Profile), error-policy-override (Web Response Profile), match (Global), rule (Global)
Examples
v Creates three entries in the Error Map, in the order in which they were created.
© Copyright IBM Corp. 1999, 2008
Specifies the name of an existing Match Rule. Use the Global match
command to create a new Match Rule.
Specifies the name of an existing Processing Rule. Use the Global rule
command to create a new Processing Rule.
181
Advertisement
Table of Contents
